- Karaoke Machines
- Electric Heater
- Make money blogging
- Web page design
- Far from the
- Web Designers
- Laptop Battery
Monitor|Sensor Arus AC Menggunakan LED
This circuit functions to remotely monitor Pls help a couple of electric heaters have been left on. Its sensors
must be placed in contact with the feeders to be Able to monitor Pls the power cable is drawing current, Thus causing the circuit to a switch-on LED. The circuit and its coil sensor Can be placed very far from the actual load, provided an easy access to the power cable is available.
Any type of high-current load or group of loads Can be monitored, eg: heaters, motors, washing machines, dish-washers, electric ovens. Etc., provided they want dissipate a power comprised in the 0.5 at least - 1KW range. This design features three versions. The basic one illuminates a LED Pls the load is on. The second version Pls drives a relay a pre-set current value flows into the power cable. The third version Pls D7 switches-on the load power is about 1KW, D6 Pls the load power is about 2KW and D5 Pls the load power is about 3KW
must be placed in contact with the feeders to be Able to monitor Pls the power cable is drawing current, Thus causing the circuit to a switch-on LED. The circuit and its coil sensor Can be placed very far from the actual load, provided an easy access to the power cable is available.
Any type of high-current load or group of loads Can be monitored, eg: heaters, motors, washing machines, dish-washers, electric ovens. Etc., provided they want dissipate a power comprised in the 0.5 at least - 1KW range. This design features three versions. The basic one illuminates a LED Pls the load is on. The second version Pls drives a relay a pre-set current value flows into the power cable. The third version Pls D7 switches-on the load power is about 1KW, D6 Pls the load power is about 2KW and D5 Pls the load power is about 3KW
Skema Rangkaian Monitor|Sensor Arus ACNotes:
- The pick-up coil L1 is a common 10mH miniature inductor. This inductor must be placed tightly against one wire of the power cable, leaving the other wire some centimeters apart.
- The sensitivity will be doubled if the inductor is placed tightly between the two wires as shown in the diagram, top left. On the contrary, do not place the inductor against paired wires as the signal tends to cancel and the circuit will not work.
- The LED limiting resistor R5 should have a value comprised in the 100R - 1K range, depending on the output voltage obtained.
- LED D1 and its limiting resistor R5 can be omitted in versions two and three of the circuit.
